Tijdens het ontkiemen ontwaakt het plantje. Water is hierbij van essentieel
belang. Zodra het zaadje voldoende water heeft opgenomen wordt het voor
het kiemplantje mogelijk het wortelstelsel te ontwikkelen. Dit wortelstelsel
breekt uiteindelijk door het zaadomhulsel heen.
HOE TE ONTKIEMEN
Manier 1
Leg op een bord vochtige tissues of watten en leg hierop de zaden. Leg
hierover weer vochtige tissues of watten en dek het geheel weer af met
een bord. Zet dit op een warme plek (21 graden Celsius) en controleer
de zaden elke dag. Kijk hierbij ook of de tissues of watten nog vochtig
genoeg zijn en besproei deze als nodig. Zodra het omhulsel breekt kan
je het zaadje in jouw groeimedium stoppen. ( groeimedium = aarde, steenwol
of coco)
Manier 2
Plaats de zaden direct in het door jouw te gebruiken groeimedium op
een maximale diepte van 5 millimeter. Besproei het groeimedium regelmatig
met water maar zorg ervoor dat het niet te nat wordt en dat het overtollige
water kan weglopen. Het is belangrijk dat bij gebruik van aarde deze
luchtig is daar lucht van wezenlijk belang is voor de stofwisseling.
Manier 3
Plaats het zaadje buiten in de grond.
Nadeel hiervan is dat zaadjes niet altijd tegen de omstandigheden buiten
gewend zijn. Zo is vaak de bodemtemperatuur te koud om succesvol te
kunnen ontkiemen. Wij adviseren u dan ook om binnen te ontkiemen onder
ideale omstandigheden en nadien het plantje pas buiten te plaatsen.
ALGEMEEN Zaden gebruiken alleen water. Voeding toevoegen in deze prille
fase kan funest zijn voor het zaadje.
Als een zaadje verworden is tot een jong plantje is dit plantje nog
heel teer. Plaats jonge plantjes daarom nooit in direct zonlicht of
te dicht onder een groeilamp. Hier kunnen ze van verbranden. Wel kan
je bij jonge plantjes langzaam maar zeker beginnen met het geven voeding.
Zaden kunnen van vrouwelijk of mannelijk geslacht zijn. Dit verschil
is te herkennen aan het begin van de bloeifase. Mannelijke en vrouwelijke
planten zullen dan van elkaar gescheiden moeten worden.
During germination the seed awakens from its inactivity. Water is essential
for this process. As soon as the seed has soaked up enough water it
is possible for the seedling to form its roots system. This root system
will eventually break through the shell of the seed.
DIFFERENT WAYS TO GERMINATE
Methode 1
Put some moist tissues or cottons on a plate and place the seeds on
top of this. Then cover the seeds with again some moist tissues or cottons
and cover everything up with another plate. Place it in a warm spot
(21 degrees Celsius) and check everyday. Also check if the tissues or
cottons are still moist and sprinkle them with water if necessary. As
soon as the shell of the seed breaks you can place the seed in your
growing medium. (Growing medium = soil, rock wool or coco)
Methode 2 Place the seeds directly in the growing medium that you want
to use at a maximum depth of 5 millimetres. Sprinkle the growing medium
with water on a regular basis but make sure you don’t make it
too wet and make sure that any surplus water can flow away. It is important
that if you use soil that the soil is airy enough because air is very
important for the seed’s metabolism.
Methode 3 Place the seed outside in the ground.
However, circumstances outside are not always perfect for germination.
For example, the ground temperature is often too low to come to successful
germination. Therefore we advise you to carry out the process of germination
indoors and to place the plant outside after this process.
IN GENERAL Seeds only use water. Adding plant nutrition in this early
stage can be fatal for the seed.
If a seed has become a young plant it is still very vulnerable. Therefore
never place a young plant in direct sunlight or too close under a 400/600
watt light. They might burn. However, at this stage it is possible to
slowly start adding plant nutrition.
Seeds can turn out to be male or female. You can see the difference
when they start flowering. When they start flowering males and females
have to be separated immediately.